Installation Guides
TOOLS YOU WILL NEED
1. Pencil or Marker
2. Measuring Tape
3. Phillips Screwdriver
4. Power Drill
GETIING STARTED
All the required installation components are wrapped in your package along with these instructions. Check that the parts you have correspond to the parts shown below.
Installation Brackets(provided)
Screw(provided)
Handle(s)
Mounting Types
Installation brackets may be used for INSIDE or OUTSIDE mounts.
Mounting the brackets level is essential for the proper operation of the shade. Shim the brackets if necessary to achieve a level alignment.
The bracket requirements and placements are the same for inside and outside mounts.
INSIDE
OUTSIDE
Top-Fixing
Use the single hole in the top of the bracket to fix to the lintel (the 'ceiling' of the recess).
Face-Fixing
Use two screws through the back plate to mount onto a facing surface (a wall or window frame)
Step-by-Step Guide:
Measure the Window:
Installation brackets may be used for INSIDE or OUTSIDE mounts.
Mounting the brackets level is essential for the proper operation of the shade. Shim the brackets if necessary to achieve a level alignment.
The bracket requirements and placements are the same for inside and outside mounts.
Mark Bracket Placement:
Hold the brackets up to the window frame at the top corners. Use a pencil to mark where the screws will go.
Drill Pilot Holes:
Use a drill to make small pilot holes at the marked spots. This makes it easier to screw in the brackets.
Attach the Brackets:
Screw the brackets into the window frame using the provided screws. Ensure the brackets are level.
Install the Blinds:
Clip or slide the headrail of the blinds into the brackets. Follow the specific instructions provided with your blinds.
Secure the Blinds:
Once the headrail is in place, secure it by closing the bracket covers or tightening any screws as required.
Test the Blinds:
Pull the cord or use the wand to test the blinds. Make sure they open and close smoothly.
Tips:
Double-check Measurements: Accurate measurements ensure a perfect fit.
Use a Level: Make sure brackets are level to avoid crooked blinds.
Read Instructions: Each blind set may have specific installation instructions; always read them thoroughly.
Installation steps
1. Measure the distance with a ruler and mark the position with a pencil
2. Drill two holes on both sides with an electric drill
3. Place the bracket at the drilling position and fix it with screws and handles
4. Finally, place the Blinds on the bracket
